Sea-Fire FM200 Owner's Manual

FM200®MODEL FT FIRE EXTINGUISHERSINSTALLATION INSTRUCTIONS OWNER’S MANUALTHIS MANUAL IS AN INTEGRAL PART OF THE SYSTEM AND AS SUCH, THEEXTINGUISHER MU

10escutcheon hole as a template and carefully drill a 5/16” (8mm) hole. Insertindicator light wire through hole and seat light assembly by pressing cl

11SYSTEM MAINTENANCEWARNING: DO NOT ATTEMPT TO DISASSEMBLE ANY PART ORCOMPONENT OF THE EXTINGUISHER. THIS UNIT IS PRESSURIZEDAND SERIOUS INJURY COULD

12OPTIONAL EQUIPMENTSDDA I Panel mounted visual/audible discharge alarm unit.ESRS-2 Panel mounted system status indicator with over-ride switch for en

13THE FOREGOING WARRANTY IS MADE IN LIEU OF ALL OTHERWARRANTIES WITH RESPECT TO THE SYSTEM INCLUDING ANYIMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS

14AREA OF DIAMETER X TUBING MODEL PROTECTION FM-200®HEIGHT SUPPLIEDCU.FT. CU.M.AUTO RANGE RANGE LBS KG IN MM FT MM25 25 .7 1.1 .5 2.5 x 9 64 x 229 10

2NOTICEDO NOT INSTALL A FT MODEL IN LIEU OF AN APPROVED FIRESUPPRESSION SYSTEM.FT MODELS ARE FOR SUPPLEMENTAL PROTECTION ONLY. FTMODELS ARE NOT TO BE

3APPLICATIONFM-200®(CF3CHFCF3), the extinguishing agent, used in all Sea-Fire“FT” series fire extinguishers, is a suitable EPA accepted alternaterepla

4CAUTION: IN CASE OF EXTINGUISHER DISCHARGE, DO NOT RUSHTO OPEN THE PROTECTED COMPARTMENT. LET THE EXTINGUISH-ING AGENT WORK FOR SEVERAL MINUTES. HAVE

5Note: Power ventilation (blowers) that exceeds one air change per minutewithin the protected compartment must be automatically shutdown uponextinguis

6CAUTION:1. DO NOT INSTALL IN AN AREA DESIGNATED FOR OCCUPANCY.2. ACCIDENTAL DISCHARGE MAY CAUSE SERIOUS INJURY.3. HANDLE THE CYLINDER WITH EXTREME CA

71/4" (6MM)HARDWARE(Figure 5)

8Figure 6Step 6 Feed detection tube into the compartment. Ensure rubber grommets (supplied) are used when tubing is fed through a bulkhead. (See Figur

9Figure 9INDICATOR LIGHT OPERATIONAll Sea-Fire extinguishers approved for marine applications are packagedwith an indicator light and escutcheon. The